Google's Bulk Sender Requirements: Who Has to Comply and What Changed
Google's Gmail sender rules have two tiers. Everyone must meet a baseline, and anyone sending more than 5,000 messages a day to Gmail must also use DMARC, alignment, and one-click unsubscribe. Here's who that actually covers and how to check yourself.

You read that Google "cracked down on bulk senders" and now you're wondering whether your 200-email outreach campaign counts. Probably not as a bulk sender. But some of the rules apply to everyone who emails Gmail addresses, and one of them, the spam-rate limit, is easy to break with a small list.
Google's email sender guidelines split senders into two tiers. Everyone must meet a baseline. Anyone sending more than 5,000 messages per day to Gmail accounts must also meet stricter bulk-sender rules. The rest of this post sorts out which tier you're in, what each one requires, and how to check.
Who counts as a bulk sender?
Google's sender guidelines draw the line at "more than 5,000 messages per day to Gmail accounts." Its FAQ words it slightly differently, as "close to 5,000 messages or more" to personal Gmail accounts within 24 hours, so treat 5,000 as the point where you should already be compliant, not the point where you start preparing.
Three details trip people up:
- It's counted per primary domain. Mail from a subdomain such as
promo.example.comcounts towardexample.com. Everyone who sends as your domain adds to one total. - It's permanent. The FAQ says bulk sender status "doesn't have an expiration date." Dropping below 5,000 later doesn't take you out of the tier.
- Only mail to Gmail counts. Volume to Outlook or Yahoo addresses doesn't add to the number, though the practices are good everywhere.

What every sender must do
These apply to anyone sending to Gmail, even a few emails a day. They've been required since February 1, 2024.
- Authenticate with SPF or DKIM. At least one, for the domain you send from.
- Valid forward and reverse DNS (PTR) records for your sending servers.
- Send over TLS.
- Keep your spam rate below 0.3% in Google Postmaster Tools. Google's own target is under 0.10%, and the FAQ says that above 0.3% you lose eligibility for mitigation.
- Format messages per RFC 5322, and don't forge a Gmail address in the
Fromheader.
Unauthenticated mail "might be marked as spam or rejected with a 5.7.26 error." If you've seen that code in a bounce, this is the page that explains it.
What bulk senders must add
Past the 5,000 line, you also need:
- SPF and DKIM both, not either-or.
- A DMARC record for your sending domain. The policy can be
p=none, but the record has to exist. - Alignment. The domain in your
Fromheader must match the SPF or DKIM domain. - One-click unsubscribe for marketing and subscribed mail. This means the
List-Unsubscribeheader together withList-Unsubscribe-Post: List-Unsubscribe=One-Click, as defined in RFC 8058, plus a visible unsubscribe link in the body.
Two clarifications from Google's FAQ matter here. A mailto: link or a body-only link doesn't satisfy the one-click requirement; it has to be the header mechanism. And transactional mail (password resets, order confirmations) is exempt, but recipients, not Google, decide which of your messages feel promotional.
Missing one-click unsubscribe doesn't trigger automatic rejection, according to the FAQ. It raises the odds that people hit "Report spam" instead, which pushes the number that does get you in trouble.
Does this apply to you? A quick sort
| How you send | Bulk tier? | What to watch |
|---|---|---|
| One-to-one outreach from your Gmail, a few dozen a day | No | Spam rate, plus authentication if you use your own domain |
| A campaign of a few hundred from one account | No | Same. One Gmail account can't send more than 500 a day (2,000 on Workspace), per our sending limits guide |
| A team of reps on one Workspace domain | Possibly, in aggregate | The 5,000 is per domain, so add up everyone's mail to Gmail addresses |
| Newsletters or product mail to a big list | Yes | Use a sending service built for it, with DMARC and one-click unsubscribe |
The pattern: a single mailbox sending through Gmail usually can't reach 5,000 a day to Gmail users, because Gmail's own per-account limits stop you first. The realistic way to cross the line is many senders on one domain, or a list-based tool sending on the domain's behalf.
How to check where you stand
- Check your authentication. Send a message to a personal Gmail address, open it, choose Show original, and look for
PASSnext to SPF, DKIM, and DMARC. Our spam diagnostic checklist walks through reading that screen. - Add your domain to Postmaster Tools. It shows your spam rate and authentication results, though low-volume domains may see little or no data.
- Look at the bounce text. Rejections include a code and reason. Authentication failures show up as codes like
5.7.26, while SPF and DKIM have their ownx.7.27andx.7.30families. - Check your unsubscribe path if you send anything list-like. Click it yourself and confirm the address stops receiving mail.
What this means if you send through the Gmail API
Maildriply is built for the left side of that table, and we'd rather be plain about it.
Every send goes through the Gmail API from your own connected account, and the From address is always that account. On @gmail.com, the authentication is handled on Google's side, so there's nothing for you to configure. On a Workspace domain they depend on your domain's DNS being set up, which you control and we can't see. Our Gmail API vs SMTP comparison covers why that path keeps alignment intact.
We also pace sends per account: when warm-up is on, a newly connected account starts at 20 emails a day and ramps up from there, all inside Gmail's own caps. That limits the volume risk, but pacing doesn't stop recipients from reporting spam. Recipients who unsubscribe through our endpoint are suppressed, and the send worker skips them on later sends.
What we don't claim: Maildriply isn't a bulk-mail platform. Sends from the dashboard don't add a List-Unsubscribe header, so it doesn't meet the one-click requirement. If your volume to Gmail is anywhere near 5,000 a day, use a service designed for that tier. For one-to-one and small-batch outreach, our email tracking best practices cover the habits that keep spam complaints low.
Nothing in Google's sender rules concerns open tracking. What gets senders in trouble is spam complaints, missing authentication, and no easy way out of a list.
FAQ
What is Google's 5,000 emails per day rule?
Senders who send more than 5,000 messages a day to Gmail accounts must meet extra requirements: SPF, DKIM, and DMARC, an aligned From domain, and one-click unsubscribe on marketing mail. The count covers your whole primary domain, and the status is permanent once you hit it.
Do I need DMARC if I send fewer than 5,000 emails a day?
Google only requires DMARC above the bulk threshold. Below it you need SPF or DKIM. Publishing a DMARC record with p=none costs little, though, and gives you reports on who is sending as your domain.
Do the rules apply to cold outreach from my Gmail account?
The authentication and spam-rate rules apply to any mail to Gmail addresses. The bulk-only rules, including one-click unsubscribe, apply only past the volume line, which a single Gmail account is unlikely to reach. Spam complaints still count either way, so keep lists targeted.
Is a one-click unsubscribe link in the email body enough?
No. Google's FAQ says one-click unsubscribe must use the List-Unsubscribe headers defined in RFC 8058, and that mailto: links and body links don't satisfy it. A visible link in the body is still required in addition.
What happens if I don't comply?
Messages may be delayed, rejected with a code such as 5.7.26, or sent to spam. Google's FAQ describes both temporary and permanent failures, depending on the problem.
If you send from Gmail and want to see who's opening, try the Maildriply extension. It's free during early access, and it sends only through your own Gmail account.
Explore Maildriply
- Gmail Chrome extension
Track sends from Gmail compose without leaving your inbox.
- Sending guardrails
Gmail API sending, per-account rate limits and one-click unsubscribe.
- Email tracking for founders
Honest outreach signal without a heavyweight CRM.
- Getting started guide
Connect Gmail and send your first tracked email in minutes.